English
200+ t/h Construction & Demolition Waste Recycling — Europe
Granite is one of the hardest and most abrasive natural stones. Our equipment handles the toughest granite quarrying conditions — reliably and at scale.
- Europe
- C&D Waste
- C106L Tracked Jaw Crusher
- 200+ t/h
-
Material
Construction & Demolition Waste -
Capacity
200+ t/h -
Output
4–8 / 8–16 / 16–31 / 31mm+
Customer Requirement
A European demolition contractor needed a mobile primary crushing solution to process mixed construction and demolition waste on-site. Feed material included broken concrete slabs, brick rubble, and mixed masonry, arriving in irregular pieces up to 630mm. The client required a single tracked machine that could be repositioned between demolition sites, producing graded recycled aggregate for direct reuse in local construction.
Equipment Configuration
Typical Granite Crushing Line · 300–500 t/h
-
Feed Size
≤630mm
-
C106L Tracked Jaw Crusher
-
3YK2160 Screening Station
-
Final Products
4–8 / 8–16 / 16–31 / 31mm+
Output & Application
4–8mm
Fine recycled aggregate · backfill and bedding
8–16mm
Road sub-base aggregate
16–31mm
Structural backfill and drainage layer
31mm+
Coarse fill · returned for secondary crushing if finer product required
Why This Equipment?
Material Hardness
Low–MediumConcrete and brick are softer than natural stone. A jaw crusher delivers the required reduction ratio in a single pass without the multi-stage setup natural rock requires.
Feed Condition
Irregular · Mixed · OversizedDemolition debris arrives in unpredictable shapes including flat slabs and chunky masonry. The C106L's 1,060 × 700mm feed opening accepts oversized pieces without pre-breaking.
Requirement
HighThe client operates across multiple demolition sites. A tracked jaw crusher relocates under its own power, eliminating the cost and time of disassembly and transport.
Contamination Tolerance
MediumC&D waste may contain rebar and embedded steel. The C106L's hydraulic overload protection releases and resets automatically when tramp metal passes through, avoiding crusher damage and unplanned downtime.
Similar Projects
Have a Similar Project?
Tell us your raw material, output, and finished product requirements, and we will provide you with equipment configuration solutions and quotes within 24 hours.
