What is the Recommended Power Supply for Site Operation?

The plant is typically powered by an on-site diesel genset or grid connection depending on site conditions. We can advise on generator sizing requirements based on the specific model configuration and expected operating conditions. Contact us with your site power availability details when requesting a quotation.

Learn More

Can the Plant Operate Without the Vibrating Feeder?

The vibrating feeder is a critical protective component and is not recommended to be bypassed. Without regulated feed, sudden surge loading of the crusher increases peak rotor stress, accelerates hammer wear, and risks blockage at the crusher inlet. For continuous production, the feeder also enables the crusher to run at optimal speed and load rather […]

Learn More

How Long do the Hammers Last, and how Difficult are They to Replace?

Hammer service life depends on material hardness and feed size. For limestone, typical hammer life is 600–1,200 operating hours. For coal or soft dolomite, expect 1,500–2,500 hours. Hammer replacement does not require specialized tools – the rotor access panel opens fully for clear access, and a single technician can change a full hammer set in […]

Learn More

How Does the Heavy Hammer Plant Compare to a Mobile Jaw Crusher in Capital and Operating Cost?

For soft-to-medium materials, the heavy hammer plant typically achieves lower cost per ton. One machine replaces a primary jaw plus secondary impactor, reducing equipment investment and maintenance complexity. Power consumption per ton of finished product is also lower when material hardness is within the design range. For hard or highly abrasive materials, the jaw crusher […]

Learn More

What Materials is the Heavy Hammer Crusher NOT Suitable for?

The PCZ series is designed for soft-to-medium materials with compressive strength up to approximately 200 MPa and low abrasiveness. High-silica materials such as granite, quartzite, and hard basalt cause rapid hammer wear and are better processed by jaw or cone crushers. Please submit your material analysis when requesting a quote – we will confirm suitability […]

Learn More

How do I Choose the Right Mobile VSI Sand Making Model?

Model selection depends on material type, feed size, required capacity, and final product standards. Our engineers can recommend the most suitable solution according to your project requirements.

Learn More

Is a Mobile VSI Plant Suitable for Aggregate Shaping?

Yes. Besides sand production, the VSI crusher is widely used for reshaping aggregate particles, reducing flaky materials, and improving aggregate quality.

Learn More

What Output Size Can the Plant Produce?

The plant is mainly used for producing 0–5 mm manufactured sand and fine aggregate, while different screen configurations can produce multiple finished products.

Learn More

What is the Difference Between VSI and 5X VSI Sand Making Machines?

The 5X VSI series generally offers higher production efficiency, optimized crushing chamber design, and improved shaping performance compared with standard VSI models.

Learn More